Magnate 2892 O-Flute 1 Flute Down-Cut Spiral Router Bit - 3/16" Cutting Diameter; 5/8" Cutting Length; 1/4" Shank Diameter; 2" Overall Length; Solid Carbide For Rigid Plastic, Acrylics, Nylons, Solid Surface, Aluminum and Type I Foams
This bit is suitable for general use with hard and soft plastics, solid surface, aluminum, and Type I foams. For Type I foams, it delivers good results on high-density material and performs even better on medium-density foam. It can also cut very low-density foam, though the results may vary. Although this bit can be used on Type I foams, the up-cut version is recommended over the down-cut.
Please note: Product images are for illustrative purposes and may vary from the actual item.
A single flute bit has a faster cut speed than a multiple flute bit and should be used where cut speed is more important than cut finish. Though a single flute bit has a rougher cut than a multiple flute bit, it allows for faster chip clearance and maximum stock removal. Single flute bits are typically more suitable for being used on lower horsepower router.
Cancer and Reproductive Harm WARNING: Cancer: Avoid Inhaling Wood Dust/Cobalt-metal-Powder ADVERTENCIA: Cancer - Evite inhalar polvo de madera/polvo metalico de cobalto Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles. More Safety Information www.p65warnings.ca.gov www.p65warnings.ca.gov/chemicals/cobalt-metal-powder www.p65warnings.ca.gov/products/wood-dust
|
