www.magnate.net

Shop Online

Home > Amana® Tool > Amana® Router Bits > Straight > Mortising Bit for Bottom Cleaning Up Shear Design, 2 Flute, Carbide Tipped

We found 4 results matching your criteria.

Up Shear Design, 2 Flute, Carbide Tipped

This Mortise bit is intended for broad, very shallow cuts, where an exceptional finish is desired. Use it to clean up previously cut dadoes and grooves, or for surfacing cuts. The up-shear configuration improves chip removal, while the cutting-edge orientation produces a smooth surface.

Sort By:

Page of 1

Amana 45560 Mortising Bit for Bottom Cleaning - 3/4" Cutting Diameter; 7/16" Cutting Height; 1/4" Shank Diameter; 2-1/4" Overall Length; Up Shear, 2 Flute, Carbide Tipped

Amana 45560 Mortising Bit for Bottom Cleaning - 3/4" Cutting Diameter; 7/16" Cutting Height; 1/4" Shank Diameter; 2-1/4" Overall Length; Up Shear, 2 Flute, Carbide Tipped

Always consult your router's operation manual before setting the RPM for your router bit. If a router bit does not include a recommended speed chart, you may begin at approximately 2,000 RPM below the maximum speed listed in the guide below. Please note that these speeds are for reference only the optimal speed may vary depending on factors such as bit size, material type, and cutting conditions. 1) Up to 24,000 RPM for bits with an overall diameter of 1". 2) Up to 20,000 RPM for bits with an overall diameter of 1-1/2". 3) Up to 18,000 RPM for bits with an overall diameter of 2". 4) Up to 16,000 RPM for bits with an overall diameter of 2-1/2". 5) Up to 12,000 RPM for bits with an overall diameter of 3". 6) Up to 10,000 RPM for bits with an overall diameter of 3-1/2".