Print Catalogs

Legacy® Shop Notes

Video Clips

News

Links

Order Information

Custom Tools

Sharpening





Home > Magnate Complete Router Bits & Accessories > Solid Carbide > 2 Flute Spiral Up-Cut Flat-End Router Bit MicroGrain Solid Carbide, Right-Hand
We found 2 results matching your criteria.

MicroGrain Solid Carbide, Right-Hand
This bit is used when creating dados without machine marks.
Sort By:
Page of 1
Magnate 9631 2 Flute Spiral Up-Cut Flat-End Router Bit - 1/8" Cutting Diameter; 1/2" Cutting Length; 1/4" Shank Diameter; 2" Overall Length
Magnate 9631 2 Flute Spiral Up-Cut Flat-End Router Bit - 1/8" Cutting Diameter; 1/2" Cutting Length; 1/4" Shank Diameter; 2" Overall Length
This bit is used when creating dados without machine marks. more info

Our Price: $14.14
Qty Add
Magnate 9635 2 Flute Spiral Up-Cut Flat-End Router Bit - 1/4" Cutting Diameter; 1" Cutting Length; 1/4" Shank Diameter; 2-1/2" Overall Length
Magnate 9635 2 Flute Spiral Up-Cut Flat-End Router Bit - 1/4" Cutting Diameter; 1" Cutting Length; 1/4" Shank Diameter; 2-1/2" Overall Length
This bit is used when creating dados without machine marks. more info

Our Price: $16.41
Qty Add
To add the above items to your cart, click the "Add" checkboxes then click "Add To Cart" >>>
   
 

Always refer to the operation manual of your router first, in the event that a router bit doesn't come with a speed chart, you may start at about 2,000 rpm slower than the maximum speed described in the chart below. Maximum speed below is for reference only, actual best performance speed varies depending on  a number of factors i.e. size of the router bit, the material to be cut, etc.

Run 24,000 rpm maximum for 1" overall diameter router bits; 
Run 20,000 rpm maximum for 1-1/2" overall diameter router bits; 
Run 18,000 rpm maximum for 2" overall diameter; 
Run 16,000 rpm maximum for 2-1/2" overall diameter router bits; 
Run 12,000 rpm maximum for 3" overall diameter router bits; 
Run 10,000 rpm maximum for 3-1/2" overall diameter router bits; 

This two flute spiralĀ  bit is designed for solid woods, wood composites and some plastics.

A up-cut spiral bit is used where an upward chip removal and a good finish on bottom are required. When using an up-cut spiral bit, chip removal is optimized but adequate hold down is also needed.